Difficulties in operation

The product does not adhere to the substrate

Incompatible primer, too much or too little dried
Temperature, humidity, dew point and condensation outside the specification
Too much material applied in one layer
Substrate contamination
The product is too diluted
The previous layer was not dried

Bubbles in the coating

The primer is dirty or incompatible
FLAMEX was applied before the primer was completely dry
The substrate temperature is too high
Spray pressure is too high or the gun is too close to the surface
Roller application is too vigorous / strong
The product is too diluted
The equipment is not clean
Temperature, humidity, dew point and condensation outside the specification

Slow drying time

Temperature and humidity outside the specified limits
The material is applied in layers of excessive thickness
The product is too diluted
The final coating was applied too early, the previous layer was not dried
The additional layer of FLAMEX was applied too early, the previous layer was not sufficiently dried

Loss of adhesion

Damage caused by water e.g.. exposure to inappropriate weather conditions
Captured condensation
The product is applied over an incompatible surface or primer
Contamination of the substrate or product
Temperature, humidity, dew point and condensation outside the specification

The product does not spray or leak

Check equipment tip, pressure, blockages, hose diameter / length
The equipment may not be clean
The product is too cold
The product has expired
The packaging stood open for too long
The material has not been adequately mixed before use
The filters are left in place

Storage

FLAMEX must be stored at temperatures between 5 ° C and 35 ° C. Containers should be stored in a dry, cool and well-ventilated area, away from direct sunlight, heat sources and flames.. Containers must be tightly closed. The product must be protected from freezing during storage and transport. The product should be stored in accordance with national regulations.

The shelf life of the product in the original packaging at a temperature of 20 ° C is 18 months from the date of manufacture, after which it can be re-checked.. The shelf life of a product is the period from the date of manufacture during which the product retains its physical integrity, remains within the specified limits, and remains suitable for its intended use.. The general precondition is that the material is stored in specific environmental conditions.

Paint variations

Some minor color variations can occur from rug to rug. Some coatings used as a top coat may fade and carbonize over time if exposed to sunlight or climatic conditions. Coatings designed to operate at high temperatures can undergo color change without affecting performance.

Health and safety measures

Appropriate precautions:

Provide local exhaust or general room ventilation during application and drying. Do not eat, drink or smoke when using the product.

Hand protection:

Use chemically resistant, impervious gloves. Wash hands after use.

Eye protection:

Wear safety goggles as it is possible to spray the product.

Skin and body protection:

Wear protective waterproof clothing and footwear.

Respiratory protection:

Respirator

First aid measures after inhalation:

Take the person out into the fresh air and keep him in a position suitable for breathing. If a person appears to have difficulty breathing or respiratory irritation, seek medical attention. If you do not feel well, seek medical advice.

First aid measures after skin contact:

Take off dirty clothes. Wash skin with mild soap and water. If skin irritation occurs: seek medical attention. Wash contaminated clothing before reuse.

First aid measures after eye contact:

Do not rub your eyes. Rinse eyes with water for at least 15 minutes. If eye irritation or inflammation persists, seek medical attention.

First aid measures after swallowing:

Rinse your mouth thoroughly, drink plenty of water. If symptoms persist, consult a doctor.